Oil Heating Element 120V 500W 1.125
1. All high temperature Oil Heating Element are available with a built in Thermocouple Type J or K
2. Sheath Material: SUS 304/316/ Incoloy 840
4. Insulation:Magnesium Oxide Powder
5. Voltage Supply 12V to a maximum of 480V
6. Maximum Temperature: 750 °C
7. Resistance Tolerance:+10% - 5%
8. Wattage Tolerance:+5% - 10%
1.Introduction of Oil Heating Element 120V 500W 1.125
Oil Heating Element 120V 500W 1.125〃is a piece of equipment made of MgO powder or MgO tube, ceramic cap, resistance wire(NiCr20/80). It is used to heat in plastic injection moulds, dies, platens and so forth.
2.Recommended for temperatures up to 750°C
All high temperature Oil Heating Element are available with a built in Thermocouple Type J or K
Sheath Material SUS 304/316/ Incoloy 840
Spirals Nickel - Chrome
Insulation Magnesium Oxide Powder
Voltage Supply 12V to a maximum of 480V
Maximum Temperature 750 °C
Resistance Tolerance +10% - 5%
Wattage Tolerance +5% - 10% (closer tolerances are available upon special request)
3.Specification Requirements For Ordering
There are many leads options available, including Glass Fibre Leads, Silicon Rubber Leads, PTFE Leads, Ceramic Beaded Leads, Braided Leads and Conduits. Please advise us of the type of leads preferred. If you would like some assistance or advise on the correct lead to use, please do not hesitate to ask.
4.When Ordering high temperature Oil Heating Element, please specify the following information
1.Type of Oil Heating Element please refer to Termination Options ).
2.Tube diameter of Oil Heating Element
3.Overlength of Oil Heating Element.
4.Wattage & Voltage
5.Lead type ( glass fibre / PTFE ) & lead length.
5.Options uses for high temperature resistance cartridge heater
3.Injection and Blowing Moulding
6.For Fastening of turbine bolts
8. Contact us: